Features

How to install?

1. Select a cool, dry and ventilated area.
2. First connect the ‘minus’ supply cable to one of the minus terminals of the Orion. The two minus terminals are interconnected. Please note that a bad minus connection could result in output overvoltage.
3. Connect the remaining cabling.
4. Optional remote on/off: replace the wire bridge on the green connector by a switch (switched current is less than 100 mA), or remove the wire bridge and connect the right-hand terminal of the green connector to the 12 V or 24 V supply with a switch (this could for example be an engine run/stop switch).
5. Adjustable output voltage: The output voltage for 12 V device can be set between 20 V and 30 V and for 24 V device it can be set between 10V and 15V by turning the pot meter (use slotted head screwdriver nr 01 – 3.5mmx0.75mm).
6. The default value of 12 V device is 26.4 and 24 v device is 13,2V. When no load is applied this can be slightly higher. When setting the output voltage always connect a small load. When set with no load the output will be lower when a load is applied. Turn counter clockwise to lower the voltage. Turn clockwise to increase the voltage.
7. The Orion is now ready for use.

Models

The Orion DC-DC Non-isolated High power Converters are available in 24/12-25, 24/12-40, 24/12-70, 24/12-70 with binding posts, 12/24-8, 12/24-10, and 12/24-20 modals.